Patz Industrial Model 9000 Liquid Transfer System - Overview & Features
Easy installation, low investment, low maintenance.
The operating principle is simple.
- Material passes over a screen with the help of a material mover.
- Liquids drop through the screen into the sump that is installed below the floor of the gutter.
- The submersible pump moves the liquid through a 2-inch PVC pipe to a discharge point at the end of the slide into your truck or container.
- The material mover takes the solids up the slide and discharges them into the container. The system uses no check valves. When the pump is turned off, liquids will flow out the sloping pipe or drain back into the sump.
Liquids drop through the screen into the sump. Two screen sizes are available: 3/8-inch and 5/8-inch.
Maintenance is low. The pump is heavy duty with an oil bath motor. It uses 230 volts, the same as the material mover but the motor draws less than 6 amps.
To eliminate corrosion, the system has a pump with stainless steel parts and utilizes PVC piping that won’t rust.
Should the pump need service, it lifts out easily. If the pump is out for service, you can still operate the material mover.
The pump’s two-inch discharge matches the intake diameter for full flow. Also, they use two-vane, nonclogging impellers.
The system is easy to install anytime - winter or summer. Your system is ready to use the day after installation.
Read more about the Patz Model 9000 Liquid Transfer System Specs
