Chain Conveyor: Model 162-A
Specifications
Standard Equipment
Overall Lengths: 11' to 66' (3.4 to 20.1 m) in 2-1/2' (762 mm) increments.
Trough Lengths: 10' to 65' (3 to 19.8 m) in 2-1/2' (762 mm) increments.
Loaded Trough Widths: 10" (254 mm) bottom; 12" (305 mm) top.
Frame: Trough with chain return, formed 16-gauge high-gloss polyester powder coated steel, 14-3/4" (375 mm) width and 13" (330 mm) height [18 -3/4" (476 mm) with covers]. Modular sections bolt together.
Chain: No. 62 detachable, steel.
Flites: 1-1/2" by 9-1/2" (38 by 241 mm) steel and 12" (305 mm) spacing.
Chain Speed: 98 F.P.M. (30 M.P.M.), constant, one direction.
Bearings: Long-life, sealed, prelubricated.
Chain Take-up: Screw-type take-up at tail pulley.
Drive Motor: None standard; available as optional equipment.
Motor Mount: None standard; available as optional equipment.
Load Capacity: Up to 45 cubic feet (1.3 cu. m) per minute, 810 pounds (367 kg) per minute or 535 pounds (243 kg) on conveyor.
Span: Up to 40' (12 m) between supports.
Optional Equipment
Drive Motors: 1 H.P. (746 watts), 1 Phase or 3 Phase.
Motor Mount: End drive, above or below the trough.
Elbow Assembly: 22-1/2° provides a 5" per foot (127 mm per 305 mm) pitch; 7-1/2° provides a 1-9/16" per foot (191 mm per 305 mm) pitch. Use two 7-1/2° elbows to make a 15° elbow.
Covers: 10' (3 m) Bolt-on covers for conveyor sections and elbow.
Loading Hopper: Funnels material into conveyor trough. 34" (864 mm) width.
Short Spout: Use where lower overall height is required.
Long Spouts are available.
Idler Stand: Attaches to rear section of conveyor to hold end off the surface.
